Unfortunately, progress on pulse input recognition has been a bit slow - partly due to unrelated “time sinks” - so this will be an overview of some other details of the JeeLabs Energy Monitor.
The mounting bracket was 3D-printed from a design on Thingiverse, with these parameters:
pcb_width = 53.5; pcb_length = 53.5; pcb_height = 2; slisse = 1; pcb_bottom_margin = 10; wall_width_thick = 2.5; wall_width = wall_width_thick-slisse; box_height = 16; This custom-sized “clip” holds the Arduino-shaped board nicely, with room for the LiPo battery.
↧